27 lines
1.4 KiB
Markdown
27 lines
1.4 KiB
Markdown
# Simple Clock
|
|
|
|
## Just clock that shows time, accurately.
|
|
|
|
### Component base is very simple:
|
|
|
|
* Arduino NANO v3 chinese replica (on Atmega-168 chip)
|
|
* 7 segment 4 digit LED indicator with common anode, FYQ-5641BD-21 (red LEDs)
|
|
* 8 resistors that limiting current on LED segments, 330 Ohms, 0.25 watts
|
|
* RTC Module GEEGROW with DS1307 chip (very basic, only RTC chip, quartz resonator, button battery, no additional memory chip)
|
|
* 5x7 cm single side prototyping board
|
|
* usb phone charger as power supply
|
|
* 2 push buttons
|
|
* 1 on/off switch
|
|
* Gainta G521G enclosure (92x66.5x28мм)
|
|
* 5m power cord
|
|
|
|
### Optionally you may need:
|
|
|
|
* Capasitor with well capacity if your charger has small capasitor on output
|
|
* Fuse, to protect your device
|
|
* DC/DC transformer if you have power supply that gives more than 5 volts or less than 4.5 volts (this will give additional surge protection if your power supply dies, this can happen after 3-5 years of uninterrupted work)
|
|
|
|
### Additional Notes:
|
|
|
|
My RTC module is not very accurate due to bad quartz chrystal calibration, looks like it is not exactly 32768 Hz and clock runs faster than it should be, giving about 5-8 seconds runaway per day. So i have to implement time correction in software (temperature changes during day/month/year is not very big - about 10 degrees Celsius, so we can use software compensation without thermal compensation).
|